ampeg svt pedal Origin Effects | BassRIG Super Vintage | Reactive Bass Preamp & DI | Inspired by Ampeg SVT

ampeg svt pedal Origin Effects | BassRIG Super Vintage | Reactive Bass Preamp & DI | Inspired by Ampeg SVTRather than dish out thousands for an original, the Origin Effects BassRig Super Vintage Bass Preamp Pedal makes it easy and affordable to incorporate the iconic sound of an Ampeg amp into any setup! This analog amp re creation comes equipped with a wide array of tone shaping controls, with standard bass, middle, and treble knobs accented with a surgically precise Amp Out EQ section to better match your amp and cab. Looking to go DI? The BassRig Super

Rather than dish out thousands for an original, the Origin Effects BassRig Super Vintage Bass Preamp Pedal makes it easy and affordable to incorporate the iconic sound of an Ampeg amp into any setup! This analog amp re-creation comes equipped with a wide array of tone-shaping controls, with standard bass, middle, and treble knobs accented with a surgically precise Amp Out EQ section to better match your amp and cab. Looking to go DI? The BassRig Super Vintage has you covered with a dedicated DI section that sports a balanced XLR output to send your tone straight to a mixer or PA system — no amp or cabinet required! With its classic sound and features optimized for today’s recording and playing demands, the Origin Effects BassRig Super Vintage Bass Preamp Pedal is a worthy addition to any gigging bassist’s gear collection.

Legendary amp sounds at your feet

Throwing the BassRig Super Vintage on your pedalboard is like adding a full-featured amp to your setup. With a flick of the Ultra Hi/Lo Cut switch, punching in additional highs and cutting out muddy lows is a breeze, crucial when going from warm-sounding cleans to gut-punching grind in the same set. The tonal tweaking only starts here, as handy controls for setting the horn cut as well as LF and HF levels polish your overdriven sound while fine-tuning the lows and highs to match whatever amp and cab you’re running, respectively.

Send stage-worthy tone to the soundboard via balanced XLR

In the case of the BassRig Super Vintage, its wide-ranging sound is complemented by an incredibly useful DI out section, tailoring this pedal to any live or studio situation that presents itself. When wired in via the BassRig Super Vintage’s balanced XLR output, you gain access to a spot-on simulation of an 8 x 10-inch bass cabinet, channeling stage-approved sound with a single pedal. Origin Effects sweetened the pot with a DI cab sim switch — this two-position switch kicks on the cab simulation when the pedal is engaged when in FX mode, with FX+BYP mode keeping the cab sim always active.

• Analog amp re-creation of a coveted Ampeg amp in a pedalboard-friendly enclosure
• Blend and Drive controls balance your wet/dry signal and crank up the gain, respectively
• Standard 3-band EQ section fine-tunes your sound
• 800/3K/220 switch sets which mid-range frequencies are controlled via the Midrange knob
• Ultra Hi setting adds high frequencies; Lo Cut cleans up muddy lows
• Amp Out EQ section with horn cut and LF/HF controls further tweaks your tone before hitting your amp and cab
• Balanced XLR output features an 8 x 10-inch bass cabinet simulation
• DI cab sim switch with engaged-only (FX) and always-on (FX+BYP) settings
• DI ground switch eliminates ground loop hum when both outputs are in use